Fit the drain hose, connect power, fill the tank and you are ready to run your first cycle.
- Put it on a dry, flat, level surface with room around it, so the air vents underneath stay clear.
- Push the drain hose onto the outlet at the rear. Put the other end in a sink. Keep the hose level or running downward. It must never sit higher than half the height of the machine, or the water will not drain.
- Plug the power cord into the port at the rear, then into a wall socket.
- Fit the lid with the Caution: Hot label facing the back of the machine. Hot steam vents from that point during a cycle.
- Remove the water tank lid and fill to the WASH line. For a sterilise-only run, the lower line is enough, at 0.2 L. Fill fresh each time. The tank empties after every cycle.
Tip: use distilled or reverse osmosis water if you can. Tap water leaves limescale on the heating element, which shows up as white spots on your bottles. Jug and carbon filters improve taste but do not remove the minerals that cause this.
Setup follows the same order: plug in, fix the drain hose to the machine and the other end to the sink, remove the water tank and fill it, replace it, switch on, load, add a Super Clean™ washing tablet, press play.
a granular step-by-step for Clean (v1) setup, beyond this summary, is not documented in the owner document.